Working principle of doll head hair transplanter

The working principle of the doll head hair transplanter is that the accommodating hole is used to accommodate the doll head. The user stops setting the working parameters through the operation screen 15, the doll head hair transplanter is installed with a crochet assembly axis, a pressure rod axis, a front and rear motion axis, a left and right motion axis, a rotation axis and a lifting axis, a total of {{1 }} Motion axes. The front and back motion axis, the left and right motion axis, the rotation axis and the lifting axis are a group, which can act as a ball-shaped movement of the doll head, simulating the manual consumption movement. The movement axis of the front and rear movement shafts and the left and right movement shafts are in the small position of the neck hole of the doll head, so that the hook component can get a relatively large movement radius when the ball movement is performed inside the doll head, and the doll head will not deform and move;

The lifting axis moves at the same time as the front and rear motion axis and the left and right motion axis. The lifting through the lifting axis can complete the vertical longitude movement on the spherical surface;

The rotation axis moves at the same time as the front and rear movement axis and the left and right movement axis, which can complete the lateral latitude movement of the spherical surface; therefore, when the front and rear movement axis, the left and right movement axis, the rotation axis and the lifting axis 4 axis receive the motion command movement , The doll head will do the rotating spherical movement according to the programmed way. The doll head hair transplanter is suitable for the new type of control of the receiving hole movement through the front and rear shaft components to complete the hair line of the doll head cover;

The movement of the containing hole is controlled by the left and right shaft components to complete the hairline with a lower position of the doll's headgear; the rotation rate of the containing hole is controlled by the rotating shaft component to control the density of each needle pitch, and the lower point of the hair foot is located on the plane of the rotating axis On the upper side, the cheeks are forward. When the hook assembly is perpendicular to the rotation axis, it starts to work, and the hook assembly can be inserted into the center of the doll's car. The pressure bar assembly can press the doll head, so that the top position of the doll head cover is pressed out of a flat position, which is convenient for the thread, and at the same time, the hook assembly moves upward and passes through the scalp of the doll head.